News
Company News
New Stoner RotoFlow™ Saves Time and Money for Rotational Molding Industry
Stoner Molding Solutions Launches RotoFlow™ Mold Release for Polyolefin and Nylon Resins
Quarryville, PA (June 2015) – Stoner Molding Solutions, the world’s largest manufacturer of rotational mold releases, announces the development of RotoFlow™ a high-efficiency mold coating for rotomolded polyolefin and nylon resins.
Stoner RotoFlow™ is proving the “small stuff” often matters most in rotational molding – especially for cause of defects, scrapped parts, and decreased production efficiency.
Inserts, tight radii, threads, and deep cavities are often hard-to-fill areas of rotationally molded parts. This common problem can result in weak or defective components of the molded part often leaving it unusable. Stoner RotoFlow™ increases the flow of polyolefin and nylon resins into these difficult areas producing a fully molded part and nearly eliminating voids, pinholes, bridging, thinning, and static lines on the surface.
Stoner RotoFlow™ users have reported higher part quality, increased production efficiency, and reduced operational waste allowing them to achieve higher production goals in less time using this product.
Stoner RotoFlow™ does not contain ozone depleting substances or chlorinated solvents. Stoner RotoFlow™ is sprayed directly onto the internal mold surface and is suitable for use with most metal surfaces.